Commercial Grade Repeater Systems

When it comes to large commercial buildings, more concrete, steel, and environment variables come into play when examining wireless connectivity, especially if your cellular/4G signal is only communicating with towers outside the building, which could be behind several walls or concrete floors. This is when most cellular providers start to see issues. Their antennas are sometimes just not powerful enough to penetrate through thick walls/floors etc.

Most commercial buildings and sky scrapers that have experienced this problem in the past, have already implemented one of these solutions. That being said, for significantly less capital than installing a new system, we can almost always upgrade your hardware while leaving the existing wire in place. Sometimes, all you need is a new antenna that supports 4G, and an upgraded signal amplifier unit (or several as the case may be).

As with all Multi-band cell phone repeater systems, the process requires the use of antennas being either installed on a roof, tower, or our personal favorite: a tower on a roof; along with running wire to amplifiers/controllers/dividers etc, and then additional rebroadcasting antennas to repeat or re-broadcast the signal effectively throughout the desired coverage area. The use of microwave or low loss cable is required and is more expensive than traditional antenna wire or coax.

The survey/estimate for cellular analysis and recommendations is billed hourly with a 3 hour minimum. Travel Expenses under 100mi included.